Hypertherm max 70 manual

Hypertherm is ISO registered. HYPERTHERM BRINGS YOU THE MAX, FOR HEAVY-DUTY, LOW COST AND HIGH PERFORMANCE AIR PLASMA CUTTING. MAX brings heavy-duty capabilities to our line of air plasma cutting systems. It delivers superior cut quality, low 70 psig ( bar); 60 psig ( bar) with shielded front-end torch partsFile Size: KB. The MAX70 ® amp plasma power supply was last manufactured in , and is no longer available for sale from Hypertherm. Effective January original torches and consumables will no longer be available. Hypertherm's Technical Service department no .  · how to replace the burner on hypertherm max 70? , PM I have max 70 for which there is no longer available burning material burner pac , I want to buy a newer burner for which there is a consumable material, but this new burner has one air hose and one red wire, while on this old two air hoses go, and There is no red wire if.

Powermax65 plasma cutter. The Powermax65 ® amp plasma power supply will stop manufacturing in December , and will no longer be available for sale from Hypertherm. We continue to make original replacement torches, consumables, and repair parts. Refer to the Torches and consumables section for additional upgrade options. MAX43 plasma system. The MAX43 ®, amp plasma power supply was last manufactured in , and is no longer available for sale from Hypertherm. Effective January original consumables for this system will no longer be available. Original torches for this system are no longer available. Please refer to the Duramax ® retrofit torch and. When starting problems occur, the operator should first evaluate the pilot arc. He raises the torch several inches above the material to provide a good, clear view of the torch. He then signals the torch to fire. After several seconds of gas flow, a pilot arc should form at the torch. A healthy pilot arc will sustain itself in the air for.

Powermax, Duramax, FastConnect, Smart Sense, HyAccess, CopperPLUS, and Hypertherm are trademarks of Hypertherm Inc. and may be registered in the United. Competitive units are in the 70 - 80 amp cutting range. Powermax G3 series standard system components q Power supply q T80 or T80M torch q. HYPERTHERM and POWERMAX are trademarks of Hypertherm, Inc. and may be Hypertherm Offices Worldwide: in the manufacturer's instructions. In.